Stress View Settings Toolbar

All functions are also shown in  View > Code Stress

Controls the piping model  3D view

Property

All results are shown for selected operation mode:

 

Button

Description

Do not show stress

Consider axial force (N/A) and torsion moment (Mt/2Z) stresses for ASME B31.1

Show the maximum result from all operation modes

Stress in operating mode from all loads

Stress in operating mode from weight loads

Stress in cold mode

Stress in test state

Fatigue failure conditions. Left button is stress range between hot and cold mode, right button is stress range between hot and installation mode. Also the operation mode should be selected, the stress range will be calculated to this operation mode

Long-term fatigue failure conditions

To display this toolbar, check  View > Toolbars > Stress View Settings