Configure parameters for natural frequency calculations.
Property |
Description |
Number of lowest frequencies |
Quantity of natural frequencies to calculate |
Eigensolution accuracy |
Convergence tolerance for eigenvalue solution |
Maximum iterations |
Maximum iteration count for eigenvalue solution |
Friction coefficient for dynamic analysis |
Friction linearization coefficient (1/mm or other length units). Set to zero to ignore friction. Use high values (e.g., 10000) to treat friction as rigid restraints. Learn more... |
Cut-off frequency |
Frequency limit for automatic mass distribution. Learn more... |
Convergence speed |
0 - Automatic selection (recommended) Values above 0 increase the number of eigenvectors used during iteration. Higher values (e.g., 2.0+) consume more memory but improve convergence speed. |
This dialog opens automatically when creating or opening an analysis file. To access in an open file, use File > Project Settings.