PASS/NOZZLE-FEM 3.5. Program Manual

2.2. Program installation

To install the program to the front-end computer it is necessary to do the following:

1. Log in with rights of administrator.

2. Insert drive with software.

3. Run Setup.exe.

4. Follow all the instructions of the installation program.

During installation process it is necessary to define program location path, as well as folder name for the program menu. Besides, dongle drivers are installed in the course of program setup, if necessary. Distribution kit includes Acrobat Reader software for documents reading.

5. Insert dongle in parallel or USB port. Perhaps, a dongle driver launch will require a system reboot.

    CAUTION: A dongle must be removed from the port during the installation process to avoid its damage.

6. Check system clock truth. Incorrect system time may cause impossibility of dongle operating.

7. To launch a program click a PASS/NOZZLE-FEM shortcut or run the executed file Nzl64_App.exe (or Nzl32_App.exe for the 32-bit program version).

In case the program is delivered by dealers of PASS Team (https://passuite.com/contact), a registration card should be sent to activate a dongle. After receiving a dongle updating string use a dongle updating program.